Preset stations can be recalled any time by pressing the corresponding preset button. When stored, the preset number will appear in the display. Press and hold the desired preset button (1-6) for more than two seconds. To store a station, select the desired band and station. Up to 18 FM and 12 AM stations can be stored. Up to six presets can be programmed for each band, enabling up to 18 FM stations and 12 AM stations to be stored in memory. Press BAND to select between FM1, FM2, FM3, AM1 and AM2 bands. Press and hold TUNE or TUNE to advance quickly. Press and hold TUNE or TUNE to enter manual tuning mode, then press TUNE or TUNE momentarily to change radio frequency up or down one step at a time. Press TUNE or TUNE to seek to the previous or next strong station. Rotate the volume knob left/right to adjust or activate the desired function/audio. Press and hold the volume knob for more than two seconds to select between the menu functions. Press the volume knob momentarily to select between audio functions. Press DISP to toggle display between various displayed information. Press DISP momentarily to save the selected time. Press the TUNE and TUNE to adjust the hours, then press the DISP, the minutes begins to flash, press the TUNE and TUNE button to adjust the minutes. Press and hold DISP until the hours begins to flash, then release. With the unit on, press DISP to display clock time. The reset button is located on the front panel. Press the RESET button to reset the unit back to the factory settings if abnormal operation occurs. Insert a 3.5mm cable in the unit's front AUX port. Press again to resume listening at the previously selected volume. Modes of operation are shown in the display.Īdjust volume using the volume knob (00-43). Press MODE to select between Radio, USB, Auxiliary Input and Bluetooth. The unit uses one 10 amp ATM fuse located beside the Heat Sink Using an incorrect fuse could damage the radio. When replacing the fuse, make sure new fuse is the correct type and amperage. Using the existing brackets or the brackets supplied with the installation kit, mount the brackets to the sides of the head unit with the screws supplied with the head unit. Step 3: Connect all wiring harnesses and slide the head unit into the mounting sleeve until it clicks into place. Step 2: Bend multiple mounting tabs around the mounting sleeve until the mounting sleeve is secure. Step 1: Insert the mounting sleeve into the installation kit or dashboard. Mounting the Head Unit: Typical DIN mounting Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.Consult a qualified technician for instructions. Please read entire manual before installation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |